B800p with bristuff

I think the right driver is qozap.ko . zaphfc.ko is the driver of 1port ISDN card.

Please scan
www.openvox.com.cn/downloadsFile/1195091231.pdf

but lspci recognizes the card as:

0000:01:01.0 ISDN controller: Cologne Chip Designs GmbH ISDN network Controller [HFC-8S] (rev 01)

Any specific hit how to disable old modules and enable new ones?

Thank you.

hello:
the info is for B800P. could you patch the file for B800P? make sure compile the bristuff with patch for B800 and without error.
regards!
James.zhu

I tried using qozap.c (openvox patch) and recompiling briistuff.
(it warned me, that in have some modules installed from before) other than that i went ok. i'm using
bristuff-0.3.0-PRE-1q

but the ztcfg -vvvv still gives me:

ZT_SPANCONFIG failed on span 1: No such device or address (6)

this is a part of compile log:

/root/bristuff-0.3.0-PRE-1v/qozap/qozap.c:1870: error: ‘struct qoz_card’ has no member named ‘st_sync’
make[2]: *** [/root/bristuff-0.3.0-PRE-1v/qozap/qozap.o] Error 1
make[1]: *** [_module_/root/bristuff-0.3.0-PRE-1v/qozap] Error 2
make[1]: Leaving directory `/usr/src/linux-headers-2.6.15-25-686'
make: *** [linux26] Error 2
install -D -m 644 qozap.ko /lib/modules/`uname -r`/misc/qozap.ko
install: cannot stat `qozap.ko': No such file or directory
make: *** [installlinux26] Error 1
****************************************************
quadBRI driver installed.
Press <Enter> to continue, or <CTRL> + <C> to abort.
****************************************************



What am i doing wrong?

Thanks.

hello:
i think you have a compilation error there, you have to solve that. if possible, please follow the installation procedures exactly. it will cause the error if use different versions of bristuff.
regards!
James.zhu

i tried with the new version, but still the same...
i also have no genzaptelconf command.

I can only do this:
/bristuff-0.3.0-PRE-1v/zaptel-1.2.10/xpp/utils# ./genzaptelconf -dv
Unloading zaptel modules:

Temporarily moving zaptel.conf aside to work around broken modprobe.conf
Test Loading modules:
- zaphfc
- qozap
- ztgsm
- wctdm
- wctdm24xxp
- wcfxo
- wcfxs
ERROR: Module wcfxs does not exist in /proc/modules
- pciradio
- tor2
- torisa
- wct1xxp
- wct4xxp
- wcte11xp
- wanpipe
- wcusb
- xpp_usb
Generating '/etc/zaptel.conf and /etc/asterisk/zapata-channels.conf'
Reconfiguring identified channels

Zaptel Configuration
======================


Channel map:


0 channels configured.


Any clues?